You are here: HomeProducts Communication RS 232 to RS 485 converter inCOM 485

RS 232 to RS 485 converter inCOM 485

RS 232 to RS 485 converter inCOM 485

RS 232 to RS 485 converter inCOM 485

The in485 RS-232 to RS-485 converter provides complete signal conversion between RS-232 and RS-485. The converters support half duplex 2-wires RS-485 communication. In addition, the 15 KV ESD protection guards against damage from electrostatic discharge. INDAS RS-232 to RS-485 converter is supplied with 2.5 KV isolation. Automatic data direction control and automatic baud rate detection is provided. The RS-485 driver is enabled automatically when the circuitry senses the TxD output from the RS-232 signal. This means that no programming effort is required to control the transmission direction of the RS-485 signal. Moreover, the INDAS RS485 converter LED indicator lets you check whether or not the converter is receiving enough power and to control RX and Tx activitiy.

Remote supervision & control of distributed network like:

Technical data
Mechanical
Housing: Polyamide (PA 6.6)
Dimensions: 42 H x 80 W x 22 D mm
Weight: 50 ± 5 g
Montage: DIN RAIL mountable
Electrical
Input Voltage: 9 to 30 VDC
Power Consumption: 10 mA @ 5 V (with termination disabled), 20 mA @ 5 V (with termination disabled)
RS-485 Side
Connector: Terminal Block
Signals: Data+, Data-, GND
RS-485 Data Direction Control: Automatic data direction control
RS-232 Side
Connector: DB9 female
Signals: RS-232: TxD, RxD, GND
Loop-back wiring: RTS to CTS, DTR to DSR and DCD
Serial
Automatic Baud Rate Detection: 2400 bps to 115.2 Kbps (InCom 485K)
Communication
ESD Protection: 15 KV
Optical Isolation: 2.5 KV rms for 1 minute
Indicators
Power indicator of good power voltage (green indicator)
Tx indicator of transmission (red indicator)
Rx indicator of reception (green indicator)